TrueBond Duet

• Capacity – Two 1.5 – 2 mL tubes, or twelve 40 mm microhematocrit tubes
• Electronic Timer – Five easily selectable preset cycles
• Removable Rotors – Swap between the 2-place fixed angle rotor for blood and urine, or the 12-place microhematocrit rotor
• Cool Operation – Unique design of the convection based cooling system protects the samples even under the heaviest workloads
• Pop Lid – The auto-pop lid locks securely during a run and pops open automatically when the cycle is done.
• Automatic Lid Lock – Centrifuge will not run with the lid open and the lid cannot be opened while samples are spinning
• Positive Lid Latching – Firm mechanical latching of the lid prevents the escape of debris
• Clear Shatter Proof Lid – Allows for safe sample observation and optical calibrations
• Reinforced Guard Bowl – Provides maximum safety and durability
• Regulatory Approvals – Certified to US, Canadian, and European Safety regulations and standards

• Dimensions (W x D x H): 7 x 7 x 7 in (17.8 x 17.8 x 17.8 cm)
• Weight – 4.3 lbs (1.95 kg)
• Factory Setting Range – 1 to 30 Minutes (± 1%)
• Voltage – 100 – 240 (+/- 10%) VAC
• Frequency – 50/60 Hz

Fixed Angle Rotor (1.5 – 2 mL Tubes)

• Quick: 30 sec / 15800 RPM / 12000 xg
• Normal: 1.5 min / 15800 RPM / 12000 xg
• Long: 2.5 min / 15800 RPM / 12000 xg
• Urine: 45 sec / 9800 RPM / 3900 xg

MHCT Rotor (40 mm Microhematocrit)

• Microhematocrit: 2 min / 15800 RPM / 13700 xg

What is the warranty on Drucker’s centrifuges?
Drucker Diagnostics provides a two (2) year parts and labor warranty.

Will I need to purchase accessories for the centrifuge separately?
All of our centrifuges are sold complete with the rotor and tube holders. No additional accessories are necessary though there are additional options available for purchase.

How often should my centrifuge be calibrated?
Drucker Diagnostics recommends the centrifuge be calibrated every 2 years or 5,000 cycles.

What should be used to clean and disinfect the TrueBond Duet?
ONLY isopropyl alcohol, soap and water, or a 10% (5,500 PPM) bleach solution should be used for cleaning and disinfection of the centrifuge and accessories. All surfaces must be dried immediately after cleaning and disinfecting.

What cleaning solutions should be avoided?
TBQ Germicidal products should not be used as they will cause damage to the centrifuge and void the warranty. The use of fully/partially halogenated hydrocarbons, ketones, esters, ethers, benzyls, ethyl benzenes, and all other chemicals not prescribed by Drucker Diagnostics should not be used as they may cause damage to the rotor chamber, rotor, tube holders, accessories, and centrifuge exterior. If this occurs the warranty will be voided.