TrueBond Set 3

• Capacity – 6 blood, urine, and fecal tubes (up to 16 x 125 mm or 15 mL), or 8 microhematocrits
• Set and Lock Controls – Switch between preset cycles, or lock to a single cycle with the easy-to-use two-button interface
• Fixed Angle Rotor – The rotor remains at a 45° angle during processing, spin 75 mm, 100 mm, and 125 mm tubes in specially designed tube holders
• Intuitive Lid Lighting – Lid lights are off when the centrifuge is ready, on when running, and flashing when done
• Cool Operation – Unique design of the convection based cooling system protects the samples even under the heaviest workloads
• Automatic Lid Lock – Centrifuge will not run with the lid open and the lid cannot be opened while samples are spinning
• Positive Lid Latching – Firm mechanical latching of the lid prevents the escape of debris
• Clear Shatter Proof Lid – Allows for safe sample observation and optical calibrations
• Reinforced Guard Bowl – Provides maximum safety and durability
• Regulatory Approvals – Certified to US, Canadian, and European Safety regulations and standards

• Dimensions: 12 x 14 x 9 in (30.5 x 35.6 x 22.9 cm)
• Weight – 12 lbs (5.4 kg)
• Factory Setting Range – 1 to 30 Minutes (± 1%)
• Voltage – 100 – 240 (+/- 10%) VAC
• Frequency – 50/60 Hz

Cycle 1: 10 min / 3900 RPM / 1600 xg (10 mL) or 1850 xg (15 mL)
Cycle 2: 5 min / 2000 RPM / 425 xg (10 mL) or 500 xg (15 mL)
Cycle 3: 6 min / 3800 RPM / 1550 xg (10 mL)

TrueBond Set 3 Manual

What is the warranty on Drucker’s centrifuges?
Drucker Diagnostics provides a two (2) year parts and labor warranty (except the rotor – see question below).

What is the warranty on the rotor?
All rotors carry a lifetime warranty. Should the rotor ever fail, for as long as you own your centrifuge, Drucker Diagnostics will replace it free of charge.

Will I need to purchase accessories for the centrifuge separately?
All of our centrifuges are sold complete with the rotor and tube holders. No additional accessories are necessary though there are additional options available for purchase.

How often should my centrifuge be calibrated?
Drucker Diagnostics recommends the centrifuge be calibrated every 2 years or 5,000 cycles.

What should be used to clean and disinfect the TrueBond Set 3?
ONLY isopropyl alcohol, soap and water, or a 10% (5,500 PPM) bleach solution should be used for cleaning and disinfection of the centrifuge and accessories. All surfaces must be dried immediately after cleaning and disinfecting.

What cleaning solutions should be avoided?
TBQ Germicidal products should not be used as they will cause damage to the centrifuge and void the warranty. The use of fully/partially halogenated hydrocarbons, ketones, esters, ethers, benzyls, ethyl benzenes, and all other chemicals not prescribed by Drucker Diagnostics should not be used as they may cause damage to the rotor chamber, rotor, tube holders, accessories, and centrifuge exterior. If this occurs the warranty will be voided.